Advertisement
e. Strip off about
1
/
" (3 mm) from the white and red wires (30).
8
f.
Tin the twisted copper shield wire, the red wire, and the white wire (31).
g. Repeat Step 1a - 1f for the other three cable ends.
30
2. Disassemble the XLR jack (HD-40-30):
a. Unscrew the tailpiece, remove the strain relief, and push the pins out of the housing (32).
b. Place the tailpiece and the strain relief onto the 12" (30cm) cable (33).
32
3. Solder the wires to the pin insert:
a. Take a close look at the pin insert. Note how the pins are numbered (34). Mount the pin
insert in a clamp if you have one, with the pins oriented so they appear as three troughs
(35). Tin each pin with solder.
34
31
33
35
15
Advertisement
