Zeppelin Design Labs cortado mkII Assembly Instructions Manual page 13

5. Grounding wire (Part #
(20). Place one of the ends of the wire in one of the holes in the corner of the board (note the
picture) (21,22). Solder the wire in place.
20
22
6. Use one of the black M3 screws to screw the standoff to the board. The standoff should be on
the component-side of the board (23,24,25).
23
25
: Strip about 1 / " off of both ends of the black grounding wire
CB-01-30)
4
21
24
13