Table of Contents
Advertisement
5. Replace the fan cover bracket. Make sure the
fan blades are visible through the rear openings
in oven before proceeding. Attach the fan cover
bracket to the unit with the 4 screws removed in
step 1 above. See Figure 11. The hood fan is now
rotated for horizontal exhaust operation.
Wire box
Figure 11
6. Attach the Exhaust Damper Assembly to the back
of the mounting plate by sliding it into the slits in the
same direction as the arrow. See Figure 12. Using
tapping screw 4 x 12 mm from the INSTALLATION
HARDWARE, tighten into place.
Mounting plate (back side)
Figure 12
C. VERTICAL EXHAUST:
OUTSIDE VENTILATION
1. Remove and save the 4 screws from the Fan Cover
Bracket. Remove Fan Cover Bracket by sliding it
in the opposite direction of the arrow on the Fan
Cover Bracket as shown in Figure 13.
Fan cover bracket
Figure 13
2. Lift the Hood Fan Unit carefully and slip wires out
of cavity. See Figure 14.
CAUTION: Do not pull or stretch hood fan wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan
blade openings are facing the back of the oven.
Note, you will need to lift the wire over the hood
fan unit so the wire will clear. See Figure 15 (A).
Then rotate the Hood Fan Unit 90˚ so that the fan
blade openings are facing the top of the oven.
See Figure 15 (B). Replace Hood Fan Unit into the
oven. Be careful not to pinch the lead wire between
the inner bracket and the Hood Fan Unit. Put the
lead wire into Wire Box. See Figure 15 (C).
(B)
4. Replace the Fan Cover Bracket. Make sure the
fan blades are visible through the top openings in
the oven before proceeding.
6
Figure 14
(A) Rotate 180˚
(C)
Figure 15
Advertisement
Table of Contents
