Preparing The Device For Start Up - Igloo CURP3 Instruction Manual

REFRIGERATION LTD

3. PREPARING THE DEVICE FOR START UP

The unit must be properly installed and located in accordance with the installation
instructions before it is used.
3.1. Installation requirements
Always use a dedicated circuit with the amperage stated on the unit.
•
Plug into an outlet designed for the plug.
•
Do not overload the circuit.
•
• Do not use extension cords.
• Never use adapters.
• Never plug in more than one unit per electric circuit.
• If in doubt, call an electrician.
IGLOO will not warranty any equipment that is connected to an extension cord or
adapter plug.
The equipment may be turned on after confirmation of the fire protection efficiency
with results of measures performed according to binding regulations!
■ NEMA Plugs
IGLOO refrigeration uses this type of plugs. If you do not
have the right outlet have a certified electrician install
the correct power source.
3.2. Unit Location
Remove cardboard angles and protective foil.
•
Install the unit on a strong and leveled surface.
•
To ensure proper operation of the unit, it must be leveled from front to back and left to right.
•
Unit may malfunction if improperly leveled.
•
• Be sure there is sufficient ventilation around the entire unit.
• Select a location away from heat and moisture generating equipment.
• Avoid installation in a high ambient or humid location.
• High ambient temperatures will cause the compressor to overwork.
• Humidity may cause rust, condensation around glass or stainless steel and decrease the efficiency of the
unit.
Pastry Display Cases | www.igloorefrigeration.com
115/60/1
NEMA-5-15R
5