Changing Power Modes - Gateway Solo 1450 Manual

Chapter 8: Managing Power

Changing power modes

You can use the following power modes to lengthen the life of your notebook's
battery:
Standby - while your notebook is in Standby, it switches to a low power
state where devices, such as the display and drives, turn off.
Hibernate - (also called save to disk) writes all current memory (RAM)
information to the hard drive, then turns your notebook completely off.
The next time you turn on the notebook, it reads the memory
information from the hard drive and opens the programs and documents
that were open when you activated Hibernate. For more information on
using Hibernate mode, see "Activating and Using Hibernate Mode" on
page 111.
Using Standby mode
Always save your work before using Standby mode. When in Standby, your
computer reduces or turns off the power to most devices except memory.
However, the information in memory is not saved to the hard drive. If power
is interrupted, the information is lost.
When in Hibernate mode, your computer saves all memory information to
the hard drive, then turns the power completely off.
If your computer
is...
On
On
In Standby or
Hibernate mode
106
...and you ...then
want to...
Enter Press
Standby mode
Enter Hibernate Click Start, Turn Off Computer, then
mode (must be press and hold
enabled) Hibernate.
Exit Standby or Press the power button.
Hibernate mode
www.gateway.com
F S
+ .
N TANDBY
S
and click
HIFT