Network Settings - Promax Platform Studio series Quick Start Manual

Network Settings

The Platform Studio has 2 onboard NIC (Network Interface Connection) ports. The top port can be used
for connection to your internal network and will show up in the system as the 'internet' connection. The
second port is reserved as a remote management port.
Onboard NIC 1 (top port) – Internet/Intranet (Used to connect to your corporate network)
Onboard NIC 2 (bottom port) – Remote Management
Clients connect directly to network adapter cards installed in the available PCIe slots of the chassis.
These can be 1GbE or 10GbE Copper NICs or 10GbE Fiber NICs. All of the NIC ports come pre-configured
and optimized for video streaming. Do not change any of the NIC port settings unless advised by a
ProMAX Technical Support Representative.
PLEASE NOTE: All client workstations must be physically connected to the Platform Server either
directly or via a qualified switch before proceeding to Server Setup.
© 2014 ProMAX Systems | All Rights Reserved
ProMAX Platform Studio Quick Start Guide
2. Slide the drive tray into the drive bay slot.
Push the drive in slowly with the lever open until the drive hits the
back of the enclosure. Now close the lever on the front slowly until
the drive grabs the back of the enclosure and you will hear a click as
the lever locks into place.
3. Secure the drive into the bay:
Lock the drives in place by sliding down the locking bar on each of
the green eject buttons (has a padlock symbol on it)
Page 5 of 24