Read Tag - Printronix T5000 Quick Setup Manual

Read Tag

Purpose This command allows data from the RFID tag
(embedded in the smart label) to merge into any
previously defined dynamic data field. It is equivalent to
the Field Number command (^FN) except that the data
come from the RFID tag.
Format ^RT
x , startblock , length , hexformat , retriescount , nomotionflag
,
reservedflag
^RT
x
startblock
length
hexformat
retriescount The number of automatic attempts to
Read Tag command.
The field number to which the data will
be assigned. The default is 0, and other
acceptable values range from 1 to 9999.
Location where data will be read from the
RFID tag. The PPI1 only supports Alien
Technology Class 1a tag, which has only
one 8–byte block. Therefore, startblock
will be set to 0, regardless of the
specified value.
The number of blocks to be read from the
RFID tag. The PPI1 only supports Alien
Technology Class 1a tags, which have
only one 8–byte block. Therefore, length
will be set to 1, regardless of the
specified value.
This flag indicates whether the data, after
being read from the RFID tag, should be
translated into hexadecimal format. The
default is 0, meaning the data will not be
translated. The other acceptable value is
1, meaning the data will be translated
into hexadecimal format.
read data from the tag if previous reads
failed. The PPI1 absorbs the number and
uses the value on the operator panel.
Read Tag
61