Mercury BRAVO Service Manual page 375

SERVICE MANUAL NUMBER 28
4. Position grounding clips on bellows. Use bellows P/N 18654, only. Do not substitute
Read and follow package label directions when using bellows adhesive.
5. Apply bellows adhesive to exhaust bellows mounting surface. Allow to dry until adhesive
6. Install exhaust bellows on gimbal housing flange.
7. Position hose clamp as shown. Torque to 35 lb-in. (4 Nm).
90-863160 MAY 2000
earlier model bellows.
a - Apply Bellows Adhesive
b - Grounding Clips
c - Part Number
is no longer tacky (approximately 10 minutes) before installing.
a - Mounting Surface
a - Exhaust Bellows
b - Hose Clamp
SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
b
a
WARNING
b
a
b
c
a
22079
22450
76660
Page 4B-33