Table of Contents
Advertisement
Physical installation
Warning! The fixture must either be fastened to a flat surface such as a stage or wall, or clamped to a truss or similar
structure in any orientation using a rigging clamp.
Warning! The fixture can cause injury or damage it if falls, attach an approved safety cable to one of the safety cable
attachment points on the base (see "Fixture overview" on page 6).
Ensure that all illuminated surfaces are at a minimum distance of 200 mm. from the fixture. All combustible materials
(wood, fabric, paper, etc.) must be at a minimum distance of 100 mm. from the head. Additionally, make sure there is
free airflow around the fixture and that there are no flammable materials nearby.
Fastening the fixture to a flat surface
The fixture can be fastened to a fixed flat surface that is oriented at any angle. Check that the surface can
support at least 10 times the weight of all fixtures and equipment to be installed on it.
Warning! The supporting surface must be hard and flat or air vents in the base may be blocked, which will cause
overheating. Fasten the fixture securely. Do not stand it on a surface or leave it where it can move or fall over. Attach
a securely anchored safety cable to the safety cable attachment point (see "Fixture overview" on page 4) if the fixture
is to be installed in any location where it may fall and cause injury or damage if the primary attachment fails.
1. Block access under the work area. Working from a stable platform, hang the fixture on the truss with the arrow
on the base facing towards the illuminated area. Tighten the rigging clamp.
2. In case of clamp failure, avoid injury or damage with a secondary attachment such as an approved safety cable
that is rated for the weight of the fixture. Connect the safety cable using one of the attachment points at the edges
of the base (see "Fixture overview" on page 4). Do not use any other part of the fixture as a safety cable
attachment point.
7.0
Advertisement
Table of Contents
