Introduction - NURI-LITES Hurricane User Manual

Introduction

Outdoor RGBW LED Fixture
UNIQUE BRACKET DESIGN
¢
TOURING PROOF
¢
SMOOTH RGBW COLOR MIXING
¢
IP65 RATING
¢
¢ SILENT OPERATION
SMOOTH PROJECTION
¢
POWERCON TRUE
¢
RDM READY
¢
Using for the first time
Warning! Read "Safety Information" on page 2 before installing, powering, operating or servicing the fixture.
Before applying power to the fixture:
Check that the local AC mains power source is within the fixture's power voltage and frequency ranges.
l
See "Power cables and power plug" on page 7. Install a
l
power cable.
AC power
Warning! Read "Safety Information" starting on page 2 before connecting the fixtures to AC mains power.
Warning! For protection from electric shock, the fixture must be grounded (earthed). The power
distributioncircuit must be equipped with a fuse or circuit breaker and ground-fault (earth-fault) protection.
Warning! Socket outlets or external power switches used to supply the fixture with power must be
locatednear the fixture and easily accessible so that the fixtures can easily be disconnected from power.
Important! Do not insert or remove live
may cause arcingat the terminals that will damage the connectors.
Important! Do not use an external dimming system to supply power to the fixture, as this may cause
damage to the fixture that is not covered by the product warranty.
The fixture can be hard-wired to a electrical installation if you want to install it permanently, or a power plug
that is suitable for the local power outlets can be installed on the power cable.
power voltage
Warning! Check that the voltage range specified on the fixtures serial number label matches the local
AC mains power voltage before applying power to the fixture.
The fixtures accepts AC mains power at 100-240 V nominal, 50/60 Hz. Do not apply AC mains power to the
fixture at any other voltage than specified.
®
IN & OUT
PowerCON TRUE
®
PowerCON TRUE power input connector on a suitable
®
connectors to apply or cut power, as this
5.0