Table of Contents
Advertisement
58
4 Configuring the system
9.Attach the end of the SCSI cable that is labeled "Tape Drive" to the
SCSI connection on the tape drive.
10.Route the SCSI cable along the front of the fan module and then
through the front and rear openings on the underside of the air baffle.
You may need to remove the air baffle to route the cable.
11.Route the end of the SCSI cable that is labeled "Server Board" to the
server board or add-in card connector. Push the cable through the
opening in the backplane, as shown in the figure below. See your
server board or add-in card documentation to locate the connection
point on the server board or add-in card.
12.Connect the 7-pin tape drive power cable to the backplane
connector that is labeled "OPT CONN".
13.Connect the 4-pin tape power cable to the tape drive.
14.Install the chassis cover.
15.(Optional): Install the front bezel.
TP01358
Figure 4. Connecting the Tape Drive Cables
Advertisement
Table of Contents
