SAMCOM FPBN10A User Manual page 8

Fuse and blasting areas
To avoid possible interference with blasting operations,
please switch off your transceiver when get close to
blasting areas and areas where deployed some
detonators. Those places posted with the words to
switch off wireless radio, you have to turn off it.
Please observe all signs and instructions.
To prevent the magnetization
With weak external magnetic of transceiver speakers, please keep
your transceiver larger than 10cm away from TV sets, computer
monitors etc, to avoid being magnetized.
8
The use of QT/DQT signaling sounds like giving you a personal
channel, but as a matter of fact, your voices can still be heard by
others if their walkie-talkies adopt the same QT/DQT signaling as
you, or all of your walkie-talkies are simply without QT/DQT signaling.
Power-saving Mode
The feature can reduce the power consumption when no signal is
received or no operation, such as button pressing, switch rotating, is
going on. The feature is activated by dealers.
In this mode, if there are 10 seconds without signal sending and
receiving or button pressing, the transceiver will automatically go into
sleep mode. if there are buttons being pressed or signals received,
the transceiver will immediately be activated, and exit the power-
saving mode.
Power Adjustment
It can be programmed through PC to adjust the power of the machine
(done by dealers). Can also hold down the MONI key when power on
to switch high low power. When you hear a tick sound it is high power,
2 tick sounds heard it is low power.
Reverse Function
It can be programmed by PC to set the reverse function(setting by
dealers).Also could hold down the PTT button to switch on/off reverse
function when power on.The reverse function will be on when you hear
a tick sound,and it will be off when you hear two tick sounds .
Timeout Ban
Overtime ban is designed to prevent any caller occupy the channel for
too long, as well as to avoid any damage resulting from prolonged
transmissions. If a transmssion lasts for a time that is more than the
dealer programmed, the walkie-talkie will stop and make a warning
tone. To stop the warning tone, please release the PTT button.
Scanning
This featue is designed to catch signals on all channels. Press the
scan/call button (press and hold for less than 2 seconds), the LED
indicator flashes green, it will scan all the channels in the scan queue
one by one in order. When a channel receives a signal, the LED
indicator will turn green for long.
21