Page 1
Test Model:FPEN10A User Manual SAMCOM FPEN10A 1) Keep Press Talk you can talk to all of person, even they are in different channel Features 2) The color change to blue ■ With GROUP button that is the voice is from ■...
Page 2
Get Familiar with the transceiver (1) PTT Transmitting (2) MONI (monitor) button VOX Function (keep press) (3) Scan/call button High/Low Power (keep press) (4) Antenna (5) Channel selection knob (6) Power/volume switch (7) Microphone (8) Status indicator (9) Battery release button (10) Earphone cap (11) GROUP button (12) Battery...
Page 3
Charging Operation Please use SAMCOM-specified charger to charge the battery; the indicator light of the charger shows the completion of charging operation. Indicator Light State Be charging Red light Charging completed Green light Please do the following steps to charge: 1.
Page 4
Installation /Removal of Antenna 1. Installation of the antenna ⑴ Plug the screw-thread end of the antenna into the socket at the top of the transceiver. ⑵ Rotate the antenna clockwise until tightening up , as shown. 2. Removal of the antenna Rotate the antenna counterclockwise to remove it.
Page 5
Operation Guide Power On/Off Rotate the Power knob clockwise until a “ka-ta” sound is heard to turn on the power. Counter clockwise to turn off. Volume Adjustment Volume knob clockwise to increase the volume, or counter clockwise to decrease it. Channel Adjustment Channel knob clockwise to decrease the channel number, or counterclockwise to increase it.
Page 6
Transmitting while holding down the PTT button. The transmission indicator turns red when the PTT button is pressed. If you speaks too loud or with your mouth getting too close with the microphone, it may distort the sound and reduce the signal clarity on the receiving side. Release the PTT button to listen to the partner's voices. Receiving Release PTT key, transceiver enter the receiving mode, the status indicator lights green.
■ VOX (Voice Operated Transmission) There are 9 levels sensitive for choise through by programmer. Troubleshooting Guide Problems Solutions Battery may have been exhausted. Please update or recharging the battery. No Power Battery may not be installed correctly. Please remove the battery and reload it.
Page 8
* The company reserves the right to change product design and specifications, and takes no responsibility for printing errors and omissions that may occur at the public division. * Since technologies are developing continuously, the corresponding changes of product design and specifications will go without notice.
Page 9
● ALWAYS use SANCON authoried accessories ( antennas, batteries, belt clips, speaker/mics, etc). Use of unauthoried accessories can cause the FCC RF exposure compliance reqirements to be exceeded. Body-worn operations are restriced to belt-clips, holsters or similar accessories that have no metallic component in the assembly and that provide at least 1.5 cm separation between the device , including its antenna, and the user's body.
Page 10
You can cause the radio to transmit by pressing the “PTT” switch. may cause harmful interference to radio communications. However, there is no ALWAYS use SAMCOM authorized accessories (antennas, batteries, belt clips, guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which speaker/mics, etc).
Need help?
Do you have a question about the FPEN10A and is the answer not in the manual?
Questions and answers