SAMCOM FPBN10A User Manual page 7

When the function is activated, the transceiver will check whether
there are calls on the channels that are set to be scanned. If a
channel is tested to have signals on it, it will switch to this channel
in order to receive voices (which channels can be scanned is
programmed and set by dealers).
Priority Scan
This feature allows you to scan frequently used channel. Dealers can
set priority channels by programming software. If you want more
information, please contact the dealer.
Without Priority Channel
For example: When scanning six normal
channels CH1, CH2, CH3, CH4, CH5,
CH6, it will take theorder as shown on the
right figure.
With Priority Channel
For example: When scanning five normal
channels CH1,CH3, CH4, CH5, CH6, in
which the channel CH2 is set the priority,
it will take the order as shown on the right.
Scan On/Off
Hold down the scan/call button (for less than 2 seconds), the
transceiver will get into the scan mode. It will quit the mode if press
the button one more time.
Reply Option
This option means whether you need to adopt the current channel
that is being scanned to reply.
When the reply option is choosed, it will use the channel at which
the scanning stops to transmit your reply voices.
2 2
Operation warning
Normal channel scan
Priority channel san
Car with an airbag
In the car with an airbag, do not put the transceiver
within the reach of the expansion of the airbag, because
the airbag inflates with great force. If the transceiver put
within the reach of expansion of the air bag, when the
airbag inflates, the transceiver may be driven by the
tremendous force generated, resulting in severe injuries
inside the vehicle.
Possible gas explosion
Some places have potentially explosive gas, if your
handheld transceiver can not be safely used in these
types of places (such as factory, CSA, UL or ENELEC),
please power off it before entering the places. Shall
not remove, install the battery or charge to the battery
in these areas. Because of such gases in the spark
will cause an explosion or fire resulting in casualties.
Mentioned above with a potentially explosive gas areas
include:
Fuel zone, like the area below deck on boats, and the
transmission or storage sites for fuel or chemical
agents; places where air contains particles, like
chemicals or such as straw, dust or metal powders.
Areas contain potentially explosive gases will have
general warning, but not all areas have this warning.
7