HEIDENHAIN TNC 320 User Manual page 535

Functions of the TNC 320 and the iTNC 530 compared 16.5
Function
PLANE function:
TABLE ROT/COORD ROT not
defined
Machine is configured for axis
angle
Programming an incremental
spatial angle according to
PLANE AXIAL
Programming an incremental
axis angle according to PLANE
SPATIAL if the machine is
configured for spatial angle
Special functions for cycle
programming:
FN17
FN18
Compensation of tool length in
the position display
Comparison: Differences in MDI operation
Function
Execution of connected
sequences
Saving modally effective functions
TNC 320 | User's Manual HEIDENHAIN Conversational Programming | 5/2013
TNC 320
Configured setting is used
All PLANE functions can be
used
Error message is issued
Error message is issued
Function available, details are
different
Function available, details are
different
The DL value from the TOOL
CALL and the tool length entries
L and DL from the tool table are
taken into account in the position
display
TNC 320
Function partially available
Function partially available
iTNC 530
COORD ROT is used
Only PLANE AXIAL is executed
Incremental spatial angle is
interpreted as an absolute
value
Incremental axis angle is
interpreted as an absolute
value
Function available, details are
different
Function available, details are
different
The tool length entries L and DL
from the tool table are taken into
account in the position display
iTNC 530
Function available
Function available
16
535