Advertisement
Cisco Antennas
Cisco
Part Number
Antenna Type
AIR-ANT3351
Diversity Omni
AIR-ANT5959
Diversity Omni
AIR-ANT2012
Diversity Patch
AIR-ANT3213
Diversity Omni
AIR-ANT1728
Omni
AIR-ANT4941
Omni-directional
AIR-ANT3549
Patch
AIR-ANT1729
Directional
AIR-ANT2506
Omni
AIR-ANT4121
Omni
All contents are Copyright © 2003 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Description
POS diversity dipoles for use with LMC radio cards with two MMCX
connectors—This antenna contains two standard 2.2 dBi "rubber duck" and
36" of cable with two MMCX connectors. It has a platform with a adhesive
backing to raise the antennas above obstructions.
Ceiling mount diversity Indoor antenna with RP-TNC—This antenna was
designed for WLAN applications for frequencies of 2400 to 2500 MHz. The
antenna is omni directional and has a nominal gain of 2.2 dBi. Its low
profile allows it to remain unnoticed in the ceiling. It comes with a clip that
permits it to be mounted to a drop ceiling cross member.
Wall mount indoor/outdoor antenna with two RP-TNC—Similar to the
above patch, but providing diversity antennas in the same package for
areas where multipath problems exist.
Pillar mount diversity, indoor antenna with two RP-TNC—Cosmetic antenna
ideal for retail or hospital environment. Includes 36" of white RG58 cable
with a separation of Siamese co-ax of 10". Has a tan cloth covering, in a 12
x 5 rectangle. Included are two mounting brackets that will keep the
antenna 6 inches off of the wall.
Ceiling mount indoor antenna with RP-TNC connector—This antenna was
designed for WLAN applications for frequencies of 2400 MHz to 2500 MHz.
The antenna is omni directional and has a nominal gain of 5.2 dBi. It comes
with a clip that allows it to be mounted to a drop ceiling cross member.
Single dipole antenna with an RP-TNC connector. The antenna provides
indoor omni-directional coverage and is for use in the 2400-2500 MHz
frequency band. It has a 90' articulation radius. It is for use with all radios
that utilize an RP-TNC antenna connector.
Wall mount indoor/outdoor antenna with RP-TNC—Special type of antenna
unique to data transmission is the patch antenna. This works well and fits
aesthetically into most work environments. Mechanically they are small
rectangles about 1/2 inch thick. They are designed to mount flat to a wall
and seem to disappear into the wall in most environments. The radiation
pattern is in the shape of a hemisphere. A typical application would be for
coverage of an area where the transmitter is located on the side of the
coverage area. Good for both indoor and outdoor use.
Wall mount, indoor/outdoor directional patch antenna. Designed for use
with any radio that features an RP-TNC antenna connector. For use in the
2400-2500 MHz frequency band. The pigtail cable is 30" long.
Mast mount indoor/outdoor antenna with RP-TNC—This antenna was
designed for WLAN applications for frequencies of 2400 MHz to 2500 MHz.
The antenna is omni directional and has a nominal gain of 5.2 dBi. It is
designed to be mounted on a round mast.
Mast mount outdoor high gain antenna with RP-TNC—This antenna was
designed for WLAN applications for frequencies of 2400 MHz to 2500 MHz.
The antenna is omni directional and has a nominal gain of 12 dBi. This
design uses an elevated center-feed to produce an elevation pattern with very
little "squint" or beam-tilt. It is designed to be mounted on a round mast.
Cisco Systems, Inc.
Page 15 of 29
Gain
2.2dBi
2.0
6dBi
5.2dBi
5.2dBi
2.2 dBi
8.5dBi
3.0 dBi
5.2dBi
12dBi
Advertisement
