Nominal Connectme Led Behavior - Permobil ConnectMe F3 Installation Instruction

ConnectMe

Nominal ConnectMe LED behavior

If the installed wheelchair software supports ConnectMe its LED will:
1. After installation at first start-up of wheelchair go purple.
2. After establishing a connection to the cellular network go green. Note! This can take some time, between 1-5
minutes depending on cellular coverage. If no 2G or 3G cellular coverage exist at all, perform this step at another location
with cellular coverage.
3. Go blue if a Bluetooth® connection is established.
4. Remain green or blue without any red colors showing when wheelchair is kept ON.
If step 1-4 is proceeded successfully ConnectMe device is correctly installed and wheelchair software do not need
to be updated.
If step 2 or 4 fails. The software needs to be updated.
If step any of step 1-4 fails after software update, please contact technical support for troubleshooting assistance.
24