Appendix - Vesta VRC-100 Installation Manual

Appendix

Gas Conversion
This boiler is configured for Natural Gas from the factory. If
conversion to Propane Gas is required, the conversion kit supplied
with the boiler must be used.
Inspect the packing between the gas valve and gas pipe
whenever they are disassembled. The packing must be
installed and must be in good condition. Failure to comply will
Danger
cause a gas leak, resulting in severe personal injury or death.
This conversion kit shall be installed by a qualified service
agency* in accordance with VESTA.DS instructions and all
applicable codes and requirements of the authority having
Warning
jurisdiction. The information in these instructions must
be followed to minimize the risk of fire or explosion and/
or to prevent property damage, personal injury or death.
The qualified service agency is responsible for the proper
installation of this kit. The installation is not proper and
complete until the operation of the converted appliance
is checked as specified in the manufacturer's instructions
supplied with the kit.
* A qualified service agency is any individual, firm, corporation or company
which either in person or through a representative is engaged in and is
responsible for the connection, utilization, repair or servicing of gas utilization
equipment or accessories; who is experienced in such work, familiar with all
precautions required, and has complied with all of the requirements of the
authority having jurisdiction.
In Canada: The conversion shall be carried out in accordance with
the requirements of the provincial authorities having jurisdiction
and in accordance with the requirements of the CAN B149.1 and
CAN1 B149.2 Installation Codes.
To convert the gas:
1
Turn off the manual gas shut off valve and the water supply to
the boiler.
Gas
2
Remove the boiler front cover by loosening the 2 Phillips
screws securing it to the case.
1
Cold water Hot water
2
2
1
Appendix
49