Advertisement
Quick Links
SYNERGY SYSTEM
Model: SNC20
Model: SNC30
Limited Warranty
Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in
a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
Salamander Designs Ltd.
•
800-535-5659
BEFORE YOU BEGIN:
!
• Unpack all parts and read instructions carefully before beginning.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
TM
They cannot be removed individually without disassembling the whole unit.
1
Connect Posts to Bottom Shelf
A
.
Square Post
Square the post to the bottom shelf.
B
.
Connect Post
Screw foot with metal washer through bottom
shelf and into the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.
WARNING: Tighten by screwing the leveler foot NOT the post.
•
www.SalamanderDesigns.com
©2006 Salamander Designs Ltd.
Short Post
Leveler Foot
Synergy System, Patented.
TM
Washer
Hex Nut
Doc No. 500-980/v10.06
SNC -1/4
Advertisement
Related Manuals for Salamander Designs SYNERGY SYSTEM SNC20
Summary of Contents for Salamander Designs SYNERGY SYSTEM SNC20
-
Page 1: Before You Begin
Limited Warranty Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. - Page 2 Add Shelf Pegs Attach Rear Panels Insert Hardware Pegs for Shelves Combine the 1” threaded studs with flat nuts. Insert one shelf peg down each post. Slide 2 sets of hardware down the two outside NOTE: There are two varieties of shelf pegs posts and 4 sets down the center post.
- Page 3 Placing Shelves Rubber Pad Double-Width Shelf If assembling model SNC20, skip to step C. Place rubber pads on top of center posts. Place double-width shelf on brackets. Adjustable Shelves Place shelves from the bottom up. Angle the shelf in between the front post and set on top of shelf pegs.
- Page 4 Parts 6 - Aluminum Posts 2 - Adjustable Shelf (SNC30 only) (PHK-370) (PHK-380) 1 - Top Shelf 1 - Spacer Tool Shelf Peg “B”- Right Shelf Peg “A” - Left (400-060) - 3/16” Hex Key SNC30 Only SNC30 Only 1 - Bottom Shelf 2 - Rear Panel 1 - Double Width Shelf 2 - Heavy Duty Shelf Bracket...