Advertisement
2
Add Shelf Pegs
A.
Pegs for Shelves
Insert one shelf peg down each post.
NOTE: There are two varieties of shelf pegs
(A and B). They are designed to cradle the
shelf in place. Refer to drawing.
A
B
B
A
A
B
B
.
Adjust Peg Height
Position the shelf peg through the Spacer
Tool and tighten at desired height. See
step 4 for fine tuning.
Note:
If installing door(s), use 2 sets
of shelf pegs at the top of short
posts to act as door stops.
3
Attach Rear Panels
A
.
Insert Hardware
Combine the 1" threaded studs with flat nuts.
Slide 2 sets of hardware down the two outside
posts and 4 sets down the center post. Allow
studs to remain loose at bottom of post.
4X
2X
8"
6"
4
1/ 2
"
REAR PANEL
S30 / S40
S20 / SVDO
REAR PANEL
EXTENDED
REAR PANEL
B
.
Position & Secure Studs
Align the Spacer Tool at the top of each post,
then position top studs through the small "Rear
Panel" hole. Repeat this step with the bottom
studs aligning the Tool along the bottom of post
to set spacing for cable passage. Use the hex key
to secure the top and bottom studs to the posts.
C
.
Place Rear Panels
Secure each panel in place with thumb nuts.
2X
TIP
To ease installation of rear
panels gently place the unit
face down on the floor to
8"
6"
improve aligning of panels.
4
"
1/ 2
S30 / S40
REAR PANEL
REAR PANEL
S20 / SVDO
REAR PANEL
EXTENDED
Doc No. 500-980/v10.06
SNC - 2/4
Advertisement
