Table of Contents
Advertisement
To
All layers of information are stored in aurora
Memory
unless filters are applied. This can be reviewed later using
the Trace Capture Review feature.
Expert to
Send all D channel signalling information to the serial port,
Comms
in a format compatible with aurora
Send the decode to the serial port in standard form.
Decode to
Comms
Decode consists of a partial decode of Layer2 and Layer 3
(Simulate)
signalling with a full hexadecimal dump of the D-channel
messages, complete with a Tx/Rx indicator, time stamp
and frame reference number.
Simple to
Send a simple decode to the serial port i.e. a simple
Comms
decode of the message type, direction and timestamp.
(Simulate)
Test to
This option is reserved for use by Hewlett Packard.
Comms
(Simulate)
Results to
Send test results to the serial port. Results may be the
Comms
output generated from a BER test or an autoservice test,
(Simulate)
or real-time errored seconds.
ASCII Hex
All bytes received on the line are formatted into ASCII and
Comms
sent to the serial port. You can use a standard
(Monitor)
communication application such as Procomm or
Hyperterminal on the remote device to capture the ASCII
hex output.
Raw Hex
All bytes received on the line are sent to the serial port.
Comms
You must use an application on the remote device which is
(Monitor)
capable of receiving raw binary bytes.
Off
Do not store or download output.
2
Issue 01 - 06/99
Protocol Trace Output
Notes: ASCII Hex Comms and Raw Hex Comms
•
Only those bytes that are in valid HDLC frames (i.e.
Layer 2 and Layer 3 frames) are sent to the serial
port.
•
You cannot apply real time filters to the
hexadecimal information.
Setting up aurora
Duet
Duet
's memory,
Expert
for Windows.
- Section 3
3 - 61
Advertisement
Table of Contents
