Greenlee H6510A Instruction Manual page 4

IMPORTANT SAFETY INFORMATION
• Keep all parts of the body away from rotating
parts when the tool is in operation. Contact with
moving parts can result in severe injury.
• Do not change accessories, inspect or clean tool
when it is connected to a power source. Accidental
start-up can result in serious injury.
• Maintain a firm grip on tool, using both hands at
all times. Serious injury can result if an operator
does not control the tool.
• Do not lock trigger in the power-ON position.
Operator can not stop tool when trigger is locked.
Failure to observe these warnings could result in
severe injury or death.
Tool and accessory may be hot
during and after operation.
Contact with hot surfaces could
result in serious injury.
Do not exceed the following hydraulic power source
maximums:
• Hydraulic flow: 45.4 l/min (12 gpm)
• Pressure relief: 138 bar (2000 psi)
• Back pressure: 13.8 bar (200 psi)
Failure to observe this warning could result in severe
injury or death.
Do not disconnect tool, hoses, or fittings while
the tool is running or if the hydraulic fluid is hot.
Hot hydraulic fluid could cause serious burns.
Greenlee / A Textron Company
Do not reverse hydraulic flow. Operation with hydrau-
lic flow reversed can cause tool malfunction. Connect
the supply (pressure) hose and return (tank) hose to
the proper tool ports.
Failure to observe this warning could result in severe
injury or death.
• Wear protective gloves when handling, removing
and installing drill bits. Drill bits can cut even when
stationary.
• Inspect tool before use. Replace any worn or
damaged parts. A damaged or improperly
assembled tool can malfunction, injuring nearby
personnel.
• Inspect the hydraulic hoses and couplings every
operating day. Repair or replace if leakage, crack-
ing, wear, or damage is evident. Damaged hoses
or couplings can fail, resulting in injury or property
damage.
• Use this tool for manufacturer's intended use only.
Use other than that which is described in this
manual could result in injury or property damage.
• Make sure all bystanders are clear of the work area
when handling, starting, and operating the tool.
Nearby personnel can be injured by flying parts in
the event of a tool malfunction.
Procedure for disconnecting hydraulic hoses, fittings
or components:
1. Move the flow lever on the hydraulic power
source to the OFF position.
2. Stop the power source.
3. Follow the sequence under Disconnecting
Hoses to prevent pressure buildup. In case
some pressure has built up, loosen hoses, fit-
tings or components slowly.
Note: Keep all decals clean and legible, and replace
when necessary.
4
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Impact Wrench