HELIX HR 1000 Assembly Manual page 12

ASSEMBLY INSTRUCTIONS 3
PAGE 12
STEP 6:
ASSEMBLE DOME COVER AND GREEN DOME COVER GASKET
Slide the dome cover over the upright tube noting that the hole in the dome cover is positioned closer to one side. That side
should face the rear of the machine, away from the user, as the dome cover is installed.
Apply only gentle pressure to fit the tabs (shown in Figure #1) in place by squeezing the dome cover slightly and sliding the
tabs into the holes in the lower plastic housing. Release the gentle pressure to snap the tabs into place. The dome cover is
shown installed in Figure #2.
Slide the rubber dome cover gasket down the center upright tube and push the gasket into place as shown, noting that the
slightly V-shaped side of the gasket faces the rear. See Figure #2 and Figure #3.
2
1
11
3
3
10
11
3
HR1000-A5.indd 12 01/08/2017 16:06