3D Systems Geomagic Touch User Manual page 8

4. Connect the power supply as follows:
a. Hook up the Power Supply (use only the supplied power supply with the Geomagic Touch device). Plug the power cord into the
power supply.
b. Plug the power cord into an available outlet (for 110V the outlet must be rated for at least 2 Amps, for 220V: 1 Amp). The green status
light on the power supply indicates that it is working correctly. Finally plug the power connector into the connector (Power) on the
back of Geomagic Touch device.
5. Allow 1-2 minutes for the device to automatically configure the Device Drivers with your Operating System and connect.
NOTE: This configuration only occurs the first time you connect your device.
6. Ensure that the Geomagic Touch Status Indicator Light is lit (it will either be blinking yellow or solid orange if working properly). If it
is not, check all of the connections. If the problem persists, contact Customer Support.
3D Systems, Inc.
Connect the Ethernet cord and power cable to the back of the Touch device.
7