Body Worn Operation; Regulatory Information; Important Note - Huawei E510 Quick Start Manual

Hspa/dvb-t usb modem
Table of Contents

Advertisement

Federal Communication Commission Interference Statement
Specific Absorption Rate (SAR)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
Your wireless device is a radio transmitter and receiver. It is designed not to exceed the limits for
reasonable protection against harmful interference in a residential installation. This equipment
exposure to radio waves recommended by international guidelines. These guidelines were
generates, uses and can radiate radio frequency energy and, if not installed and used in
developed by the independent scientific organization ICNIRP and include safety margins designed to
accordance with the instructions, may cause harmful interference to radio communications.
assure the protection of all persons, regardless of age and health.
However, there is no guarantee that interference will not occur in a particular installation. If
The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR
this equipment does cause harmful interference to radio or television reception, which can be
limit for wireless devices is 2.0 W/kg and the highest SAR value for this device when tested complied
determined by turning the equipment off and on, the user is encouraged to try to correct the
with this limit.
interference by one of the following measures:
Reorient or relocate the receiving antenna.

Body Worn Operation

Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
Important safety information regarding radiofrequency radiation (RF) exposure
connected.
To ensure compliance with RF exposure guidelines the device must be used with a minimum of 1.5
Consult the dealer or an experienced radio/TV technician for help.
cm separation from the body.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
Failure to observe these instructions could result in your RF exposure exceeding the relevant
for compliance could void the user's authority to operate this equipment.
guideline limits.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must

Regulatory Information

accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

The following approvals and notices apply in specific regions as noted.
Radiation Exposure Statement:
FCC Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum
This equipment has been tested and found to comply with the limits for a Class B digital device,
distance20cmbetween the radiator & your body.
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
This transmitter must not be co-located or operating in conjunction with any other antenna or
against harmful interference in a residential installation. This equipment generates, uses and can
transmitter.
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
The availability of some specific channels and/or operational frequency bands are country
interference will not occur in a particular installation. If this equipment does cause harmful
dependent and are firmware programmed at the factory to match the intended destination. The
interference to radio or television reception, which can be determined by turning the equipment off
firmware setting is not accessible by the end user.
and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
These limits are designed to provide
12

Advertisement

Table of Contents
loading

Table of Contents