Controller Position - Pride 1170XL Plus 2VHD, 1170XL Plus 3VHD Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicu-
lar to the floor. See figure 13.
2. Loosen the jam nut.
3. Turn the adjusting screw to raise or lower the front
of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.

Controller Position

You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use. See figure 13.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 13.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off power to the controller.
2. Disconnect the controller from the power base.
3. Cut the wire tie(s) securing the controller harness
to the armrest.
4. Flip up the armrest so it is perpendicular to the
floor.
5. Loosen the setscrew on the controller bracket. See
figure 13.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller harness so that it cannot be
pinched in the seat hinge.
11. Use wire ties to secure the controller harness to the
armrest. See figure 10.
12. Plug the controller into the power base. See
figure 6.
24
Figure 13. Underside of Armrest
MOUNTING HARDWARE
Figure 14. Foot Platform Height Adjustment
www.pridemobility.com
CONTROLLER BRACKET
SETSCREW
Jazzy 1170 XL Plus Series