Advertisement
9. USB extension cable:
The USB extension cable must be installed to an easily accessible place, because
in case of updating or configuring the settings, the pendrive will be connected to this
cable. If there are two CPUs, then both USB extension cables have to be accessible,
as the CPUs have to be updated separately. Recommended installation place is the
glove compartment.
CONFIGURATION AND SOFTWARE UPDATE OF THE LASER UNIT:
The KIYO D Ultimate laser unit can be configured and its software updated with the help of
a pendrive and a computer. The setup and update software can be downloaded from the
website of the manufacturer: https://kiyotechnology.com. After updating the software,
some feature of the device may differ from what is written in this manual.
ALARMS OF THE KIYO D ULTIMATE:
When only the laser unit is used, the device communicates with LED lights and beeping
sounds. If the GPS U1 is connected, voice alarms of the selected language clarify the
different warnings.
Warning! Some of the alarms may change with new software updates!
• Short beeping sound, continuous GREEN light: the device is ready to use in active
mode.
• Three beeping sounds and flashing GREEN light: the device is ready to use in
passive mode.
• Rhythmical beeping sound and flashing RED light: obstacle detected in parking
assist mode.
• Rhythmical beeping sound and flashing RED and GREEN light: laser detection alert.
• Change in the rhythm of the laser detection alert: The active mode timer has expired
and the device changed back to passive mode. After the reset time, a beeping sound
indicates that the device is in active mode again.
• Silent, flashing RED and GREEN light: unknown laser detection alert, with muted
sound.
• Crackling beeping sound and flashing RED and GREEN light: unknown laser
detection alert, with enabled sound
• Silent, continuous RED light: The pendrive is still connected after the last update
(so the device is not ready to use), or the system is deactivated with the panic button.
• Continuous beeping and RED light: no sensor connected.
• Silent, quickly flashing RED light: update in progress.
• Silent, slowly flashing RED light: corrupted or no update file can be found on the
pendrive.
• Continuous RED light and repeating beeping sounds:.One of the sensors may be
malfunctioning, the number of the repeating beeping sound indicates the number of the
port where the damaged sensor is connected.
13
Advertisement
