Advertisement
c) If the license plate frame of the vehicle is angled, then for the best efficiency, the sensors
have to be aligned to be parallel with the road. The angle of the sensors can be adjusted
with the screw on the side of the mounting bracket.
Remove the sensors from the special frame and fasten it to the vehicle. With a double-
sided tape, fasten the sensors to the outer panel, which is parallel to the inner panel of
the frame. There you can align the angle of the sensors properly. After aligning them to
horizontal, fasten the angle with the fastening screw on the side of the bracket.
d) After following the steps of removing the frame, mounting the sensors and then
reattaching the special frame, the sensors will be aligned to horizontal and the license
plate can be put back.
e) Find a suitable position for the central unit under the dashboard of the vehicle!
10
Advertisement
