Download  Print this page

Disassembly Instructions - Toshiba 27A41 Service Manual

Hide thumbs

Advertisement

更多难得资料请到江南家电维修论坛免费下载!
http://bbs.520101.com
1. REMOVAL OF ANODE CAP
Read the following NOTED items before starting work.
*
After turning the power off there might still be a potential
voltage that is very dangerous. When removing the
Anode Cap, make sure to discharge the Anode Cap's
potential voltage.
*
Do not use pliers to loosen or tighten the Anode Cap
terminal, this may cause the spring to be damaged.
REMOVAL
1. Follow the steps as follows to discharge the Anode Cap.
(Refer to Fig. 1-1.)
Connect one end of an Alligator Clip to the metal part of a
flat-blade screwdriver and the other end to ground.
While holding the plastic part of the insulated Screwdriver,
touch the support of the Anode with the tip of the
Screwdriver.
A cracking noise will be heard as the voltage is discharged.
Screwdriver
Alligator Clip
GND on the CRT
2.
Flip up the sides of the Rubber Cap in the direction of the
arrow and remove one side of the support.
(Refer to Fig. 1-2.)
Rubber Cap
CRT
Support

DISASSEMBLY INSTRUCTIONS

GND on the CRT
CRT
Support
Fig. 1-1
Fig. 1-2
3. After one side is removed, pull in the opposite direction to
remove the other.
NOTE
Take care not to damage the Rubber Cap.
INSTALLATION
1. Clean the spot where the cap was located with a small
amount of alcohol. (Refer to Fig. 1-3.)
Location of Anode Cap
NOTE
Confirm that there is no dirt, dust, etc. at the spot where
the cap was located.
2.
Arrange the wire of the Anode Cap and make sure the
wire is not twisted.
3.
Turn over the Rubber Cap. (Refer to Fig. 1-4.)
4. Insert one end of the Anode Support into the anode button,
then the other as shown in Fig. 1-5.
Support
CRT
5.
Confirm that the Support is securely connected.
6.
Put on the Rubber Cap without moving any parts.
Fig. 1-3
Fig. 1-4
Fig. 1-5

Advertisement

loading

  Also See for Toshiba 27A41

  Related Manuals for Toshiba 27A41