Table of Contents
Advertisement
Installing the Cisco MDS 9132T Switch
While removing the fan module, keep your hands and fingers away from the spinning fan blades.
Note
Let the fan blades completely stop before you remove the fan module. Statement 258
To remove the existing fan module, follow these steps:
Step 1
On the fan module that you are removing, press the two sides of the fan module handle next to where it connects to the
fan module and pull on the handles enough to unseat it from its connectors.
Step 2
Holding the handle, pull the module out of the chassis.
Do not touch the electrical connectors on the back side of the module and prevent anything else from coming
Caution
into contact with and damaging the connectors.
Step 3
Insert a fan blank module as shown in
fan module.
Figure 17: Inserted Fan Blank Modules, on page 40
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
Installing and Removing Fan Modules
if you do not have a new
41
Hide quick links:
Advertisement
Table of Contents
