Pride ULTRA 1103 Owner's Manual page 27

V . C O M F O R T
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several
different heights in 1.27 cm (0.50 in.) increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 18.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 18.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Quick Release Fasteners: The foot platform is attached
to the power base with two quick release fasteners. See
figure 18. Each quick release fastener consists of a bolt, a
lever and a nut. See figure 19. The lever has a cam on the
end that allows it to clamp into place. The quick release
fastener has two states: clamped and unclamped. When the
lever is open, the quick release fastener is unclamped. When
the lever is closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut anticlockwise one-quar-
ter or one-half turn.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 20.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew to raise or lower the front of the foot
platform.
Jazzy 1103 Ultra
A D J U S T M E N T S
FOOT PLATFORM BRACKET
Figure 18. Foot Platform Adjustment
Figure 19. Quick Release Fastener Operation
Figure 20. Bottom View of Foot Platform
www.pridemobility.com
QUICK RELEASE FASTENERS
UNCLAMPED
NUT
BOLT
LEVER (OPEN)
FOOT PLATFORM
RETAINING PIN
LEVER (FULLY CLOSED)
CAM
CLAMPED
SETSCREW
27