Table of Contents
Advertisement
V .
C O M F O R T
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and apply
thread lock.
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller to the power pod.
15. Reinstall the rear shroud and tighten the fasteners.
Seat Position Adjustment
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud.
3. Unplug the controller connectors from the power
pod.
4. Remove the seat from the power base.
5. Remove both extrusions from the bottom of the seat.
6. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or rearward. See figure 15.
7. Fasten the extrusions back onto the bottom of the seat.
8. Reinstall the seat.
9. Plug the controller connectors into the power pod.
10. Reinstall the rear shroud and tighten the fasteners.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release le-
ver. The lever is located on the right side of the seat base.
See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or rearward to the desired position.
3. Release the lever.
24
A D J U S T M E N T S
EXTRUSIONS
Figure 15. Seat Position Adjustment
www.pridemobility.com
SEAT MOUNTING HOLES
Jazzy 1103 Ultra
Advertisement
Table of Contents
