Other Alarm Symptoms; Cooking Zone With Electric Heating Element Not Functioningt - AEG 88101 Service Manual

2.4 Other alarm symptoms

Alarm Display
symptoms
Buzzer defect
Individual display
elements do not
illuminate or do not
do so continuously.
Penetrating aromas
from the hob when
warm.
Pots cause noises

2.5 Cooking zone with electric heating element not functioningt

Alarm symptoms
Cooking zone not
functioning.
DGS-TDS
21.04.08
8
Possible Alarm
Cause
Touch control
defect.
Defective display
elements
Coils subjected to a
manufacturing
defect.
Unsuitable pots.
Normal sound level
Possible Alarm Cause Alarm Remedying
No phase 2 power voltage
or wrong connection
Electric heating element
defect
Relay defective
If the above should not
succeed.
Alarm Remedying
Replace Touch Control.
Replace Touch Control.
The aroma is non-toxic. Replace the affected
coils. These also have a slight arom when
cold. Clean the glass and aluminium sheet.
See Chapter 4 Pot Detection Information.
Interference noises result from the high
working frequency of the induction. This can
vary from pan to pan.
When measured in operation pursuant to
EN60335 §11-3 pursuant to EN60704 with 4
pots <47dBA.
A pot with boiling water has approx. 60-
62dBA.
(1) Check the pin configuration and
230V AC between N (4) and the phases
at terminals 1 and 2.
(7) Check whether the electric heating
element is open between the connections
or whther it has short-circuited. Replace
the heating element if defective.
8) Check whether the rely is defective
and whether no voltage is applied to the
electric heating element. Also refer to the
circuit diagram.
Replace the filter module with the relay
599 519 523 EN