Troubleshooting Guide - Kidde P4010DCSCO-W User Manual

4. Troubleshooting Guide

Trouble Condition Visual Indications
low battery
fault Mode
end of Unit life
end of Unit life hush
Mode (after push/
release test/hush
button during end
of life)
network error
network error hush
(after button push
during network error)
If you require further information please contact Product Support at 1-800-880-6788 or write us at:
Kidde, 1016 Corporate Park Drive, Mebane, NC 27302. Our internet address is www.kidde.com.
Audible Indications
Chirp every 60 sec, voice every
30 sec: "Replace alarm."
Voice stops after 5 mins.
Chirp every 30 sec.
Voice every 30 sec: "Error, see
trouble shooting guide"
After 5 mins: no voice message
Double chirp every 30 sec.
First 5 mins: Voice every 30 sec:
"Replace alarm, press button to
Amber
temporarily silence." Voice stops
after 5 mins. After 7 days: Chirps
continue. Voice every 30 sec for
LED
5 mins: "Replace alarm."
blinks
Voice "Temporarily Silenced."
End of Unit Life chirps silenced
for 24 hrs. (7 days after End of
every
Unit Life chirps begin, the chirps
cannot be silenced.)
5
seconds
Chime every 30 secs. Voice
every 30 sec: "Connection lost,
press button to temporarily
silence."
After 5 min: no voice messages
(Note: network must have
3 or more alarms for voice
messages.)
Voice "Temporarily
Silenced."
Action:
*Remove, discharge, dispose unit, and replace as
soon as possible.
*See Cleaning Your Alarm section.
* Push Test/Hush button once to attempt to reset
the unit .
*Red LED will blink out an error code (number of
blinks) when Test/Hush button is push/released
once. Report the number of blinks to customer
service if needed.
* Push/release Test/Hush button to temporarily
silence (see End of Unit Life Hush Mode section
below)
* Remove, discharge, dispose unit, and replace as
soon as possible.
* Remove, discharge, dispose unit, and replace as
soon as possible.
* Push/release the Test/Hush button once to
silence for 24 hrs at a time.
*Red LED will blink out an error code (number of
blinks) when Test/Hush button is push/released
once. Report the number of blinks to customer
service if needed.
* Push and hold Test/Hush button until two beeps
are heard (approx 4 sec) and then release the
button to try to rejoin. Or reset (section 9.3) and
then rejoin (section 9.2).
*If error persists, remove, discharge, and replace
alarm as soon as possible.
7