Table of Contents
Advertisement
3.6.2 Port Forwarding
You may setup virtual servers to provide service on internet.
Virtual Server Setting:
Enable/Disable the port forward.
IP
Address: This is the port number on the WAN side that will be used to access the
application. You may define a single port or a range of ports. You can use a comma to add
multiple ports or port ranges.
Port Range:
This is the port used to forward the application. It can be either a single port or a
range of ports. For the TCP and UDP services enter the beginning of the range of port
numbers used by the service. If the service uses a single port number, enter it in both the start
and finish fields.
Protocol:
Select the protocol (TCP, UDP, or TCP & UDP) used to the remote system or
service.
Comment:
You may key in a description for the IP address.
38
Advertisement
Table of Contents
