Assembly - Nature Power 60032 Owner's Manual

No assembly required except the connections for operation. See Operating Instructions
Check for damaged connectors or indicators on the controller before each use. Replace the controller
if damaged.
•
Check the ratings of the solar panel, and battery before connecting the charge controller. The
controller's rated voltage is 12 volts and the input current must be less than 30 amps.
•
Check that the current density of the connecting cables is less than 4A/mm², that helps to reduce
the line voltage drop.
•
Do not expose the charge controller to rain or wet conditions. The controller is NOT weather-
proof.
•
When connecting the system for use, ensure that the connections are positive-to-positive and
negative-to-negative. Wrong connections will cause damage to the controller, solar panel and/or
the battery.
1. Arrange the controller, solar panel, battery, and any load within the range of the connecting cables
(only the controller is provided in this package). WARNING: Keep the controller away from direct
sunlight, electric heaters, or high temperature electrical appliances.
2. Cover the solar panel to prevent arcing while making system connections.
3. Connect the controller to the battery first, then to the solar panel, then to any other load in the
system as shown below. WARNING: Failure to follow the above sequence may damage the
controller.

Assembly

Before Each Use
Operating Instructions
page 7/10
Page 7 of 11