Blueant V1 User Manual page 16

BlueAnt
Basic Headset Functions
For easy reference, also see the Button/Function Matrix and the Quick Start Guide.
1. Power ON: Press and Hold the BAB
displayed. After powering ON, your headset will automatically connect to your last used phone if it is in operating range. If this phone
is not range, the V1 will enter idle mode after 60 seconds. If no phone has yet been Paired, the V1 will enter into Pairing mode.
2. Power OFF: Press and Hold the BAB
3. Enter Pairing Mode: With the V1 OFF, Press and Hold the BAB
will stay in pairing mode for 2 minutes then will go into idle mode. To re-enter pairing mode, repeat this step. If you had already
paired 5 devices and want to pair again, you will need to RESET the V1 to enter pairing mode.
4. Make a Call: Dial the number using your phone as normal. Audio will automatically transfer to the headset.
5. To Answer or End a call: Click the BAB
Click the BAB
6. Reject*: a call: Press and Hold the BAB
7. Redial*: the last call, Press and Hold the Volume
8. Activate Voice Dialing*: While connected to a phone, Press the BAB
previously recorded into your phone (see your phones user guide for specifi c instructions).
9. Volume level: Click Volume
for the next call. Be sure to use the headset at a comfortable and safe volume level.
10. Disconnect / Transfer: To disconnect the V1 with the currently connect phone Click Volume
once. This will also transfer an ongoing call to the phone.
16
for 3 seconds. The solid Blue LED will light up. If the battery is low a solid Red LED will be
for 3 seconds. The Red LED fl ashes three times.
once when there is an incoming call.
to end the call.
for 1 second when there is an incoming call.
or Volume during a call to adjust the desired level. Volume changes will be remembered
for about 6 seconds until the LED fl ashes Blue. The V1
Button for about 3 seconds. To cancel Redial, click the BAB
once. Voice commands must have been
and Volume together