General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference; Circular Saw Safety Warnings - Makita HS6101 Instruction Manual

Vibration
The vibration total
determined according to EN60745:
Model HS6100,HS6101
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model HS7100,HS7101
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Circular Saw
Model No./ Type: HS6100, HS6101, HS7100, HS7101,
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
value (tri-axial vector
2
) : 2.5 m/s or less
h,W
2
2
) : 2.5 m/s
h,M
2
2
) : 2.5 m/s or less
h,W
2
2
) : 2.5 m/s
h,M
2
ENG900-1
sum)
000331
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
ENG901-1
CIRCULAR SAW SAFETY
WARNINGS
Cutting procedures
1.
area and the blade. Keep your second hand
on auxiliary handle, or motor housing. If both
hands are holding the saw, they cannot be cut by
the blade.
2. Do not reach underneath the workpiece. The
guard cannot protect you from the blade below
the workpiece.
3. Adjust the cutting depth to the thickness of
the workpiece. Less than a full tooth of the blade
teeth should be visible below the workpiece.
4. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the
work properly to minimize body exposure, blade
binding, or loss of control.
ENH101-17
A typical illustration of proper hand support, workpiece
support, and supply cord routing (if applicable).
000157
5. Hold the power tool by insulated gripping
surfaces only, when performing an operation
5
31.12.2013
Yasushi Fukaya
Director
DANGER: Keep hands away from cutting
GEA010-1
GEB013-6