Battery Installation; Power Lift Recliner Disassembly - Pride Mobility Power Lift Recliner Series Owner's Manual

POWER LIFT RECLINER SERIES

BATTERY INSTALLATION

Your power lift recliner is equipped with a battery
backup system that will activate during a power
failure. The backup system is powered by two 9V
batteries (not included) that need to be installed into
the external transformer.
Follow these steps to install the batteries:
1. Unplug the external transformer power lead from
the electrical outlet.
2. Open the marked battery door on the external
transformer.
3. Install two 9V batteries into the external
transformer (Fig. 4.2).
4. Replace the battery door.
NOTE: Always make
transformer is equipped with two fresh 9V
batteries, since the battery backup system
does not recharge itself. Fresh batteries are
defi ned as 9V alkaline batteries that are
replaced every time the battery backup system
is activated during a power failure, or once a
year if the battery backup system has not been
activated.
NOTE: If you unplug your power lift recliner
for an extended period of time (more than one
hour), remove the batteries from the external
transformer. The power lift recliner will draw
power from the batteries even when it is not
in use.

POWER LIFT RECLINER DISASSEMBLY

The back portion of KD power lift recliners can be
removed to make service and transport of the power
lift recliner more convenient.
Follow these steps (4.3.1 through 4.3.3) to
disassemble the power lift recliner:
14
sure the external
www.pride-mobility.co.uk
IV. ASSEMBLY/DISASSEMBLY
BATTERY DOOR
EXTERNAL TRANSFORMER (TOP AND BOTTOM VIEW)
Figure 4.2 Power Lift Recliner Battery Backup Location
4.3.1 Remove the bottom of the back leather fl ap from the
hook and loop fl aps on the chair base.
POWER LEAD
Power Lift Recliner Series