Power Lift Recliner Placement - Pride Mobility Power Lift Recliner Series Owner's Manual

Hide thumbs Also See for Power Lift Recliner Series:

Table of Contents

IV. ASSEMBLY/DISASSEMBLY

NOTE: Depending on power lift recliner width, you may need to slide on one side of the chair-

back at a time. If this is the case, level the chair-back before pressing down to lock into position.

4.1.3 Push ﬁ rmly on the top of the chair-back to lock into

position. Listen for a click on each side to ensure the

chair-back is locked in properly.

NOTE: Pull up on the chair-back to ensure that it is locked in place. If the back can be pulled off,

then repeat steps 4.1.1 through 4.1.3.

POWER LIFT RECLINER PLACEMENT

Your power lift recliner should be placed near a standard electrical outlet on dry, level ground where there is

ample room to allow for proper operation. Pride recommends that you have the assistance of an attendant

when positioning the power lift recliner to avoid the possibility of injury when lifting.

Follow these steps to position the power lift recliner in a safe manner:

1. Place the back of the power lift recliner 76 cm (30 in.) from the nearest obstruction while the power lift

recliner is in the seated position. This measurement may vary depending on model.

2. Adjust the leg levelers to stabilise the power lift recliner (Fig. 3.2).

3. Install the batteries into the external transformer if applicable. Refer to "Battery Installation" for more in-

formation.

4. Position the external transformer on the ﬂ oor in an open, well-ventilated area where it will not be an ob-

struction or, if equipped, utilise the optional wall mount.

5. Position the low voltage connection cable where it will not be pinched between the frame and the lift

mechanism.

6. Connect the low voltage connection cable to the external transformer if it is not already connected.

7. Plug the power lead directly into the electrical outlet. Do not use an extension lead!

NOTE: If you discover a problem at any point during the set-up and positioning of your power lift

recliner, stop and contact your authorised Pride Dealer immediately. To avoid personal injury

and/or product damage, do not plug the unit into the electrical outlet until the problem is cor-

rected and do not attempt to ﬁ x electrical problems by yourself.

Power Lift Recliner Series

"CLICK"

4.1.4 Attach the bottom of the back leather ﬂ ap to the

hook and loop ﬂ aps on the bottom of the chair base.

www.pride-mobility.co.uk

POWER LIFT RECLINER SERIES

Table of Contents