Assembly/Disassembly; Power Lift Recliner Set-Up - Pride Mobility Power Lift Recliner Series Owner's Manual

POWER LIFT RECLINER SERIES
Your power lift recliner may require some assembly before initial use. It may also require disas-
sembly to make servicing the power lift recliner more convenient. If your power lift recliner is a
Knock-Down (KD) model, follow the instructions in "Power Lift Recliner Set-up." If your power
lift recliner is not a KD model, proceed to "Power Lift Recliner Placement."

POWER LIFT RECLINER SET-UP

Your power lift recliner will arrive in the knock-down position (Fig. 4.1).
Figure 4.1 Knock-Down (KD) Position
Follow these steps to assemble the power lift recliner:
4.1.1 Remove the packaging from the back portion of the
power lift recliner and check that the locking clip is
in the vertical position. Reposition if necessary.
12
4.1.2 Slide the left and right KD sleeves of the chair-back
onto the KD connections on the arms and seat of
the power lift recliner. Drape the hand control and
cable over the chair base, then slide the back onto
the base. Ensure the hand control cable is routed
through the rear of the lift chair.
www.pride-mobility.co.uk
IV. ASSEMBLY/DISASSEMBLY
Power Lift Recliner Series