Honda Odyssey Service Manual page 9

Door Detector
Remote Programming
Switch
OTC Board
Driver power seat harness
Rollx Vans Power Seat Connector
Rollx Vans neutral safety
Green wire
Important Item Information and Locations
Kneeler
Passenger power seat harness
Rollx Vans Power Seat Connector
OEM Blue wire
C415 connector
(Right rear of van below tire cover)
function is to pull the van closer to the
The One Touch Controller Board is
the main controller which operates the
The Door Detector Is a device we
use to monitor the passenger sliding
(Lower front corners of the van)
Rollx Vans installs a Power Seat
Connector to allow for quick removal
of front seats. The OEM seat gets its
power, ground, and heat functions
through this connector.
More information can be found in the
Power Seat section.
(Near Passenger Side Kick Panel)
The neutral safety that Rollx Vans
uses for its OTC system is achieved
by tapping into OEM neutral safety
location as shown which then goes to
the fuse panel.
See OTC Wiring Diagram for more
information.
Page 4
Kneeler, One Touch Controller
Board, Door Detector, Remote
Programing Switch:
The Kneeler is an actuator that is
connected to the rear axle on the
passengers side of the van. Its
ground so that there is less of an
incline on the ramp.
functions of the passenger sliding
door, the ramp and the kneeler.
door status. Open or Closed.
Power Seat Connector
OEM Neutral Safety