Charging Your Drone; Battery And Charger Specifications; Syncing The Quad And Remote - Quadrone Sparrow Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

• To charge your Quadrone, first disconnect

the battery from the drone and slide it out

of its holder. Plug the provided USB

charger into a USB port. Now connect the

USB charger to the battery. A red light on

the charger will turn on, indicating the

battery is now charging. The red light will

turn off again once the charging process

has completed. Always charge your

Quadrone under adult supervision and

out of the reach of children. Charging

time is approximately 30 minutes. When

you are ready to fly your Quadrone again,

reinsert the battery into its slot on the

bottom of the drone.

Battery and Charger Specifications

Battery Type

Li-Po Battery

Carbon-Zinc

Battery

(Non-Rechargeable)

1. Turn on your Quadrone by plugging the battery into the drone. Place it

on a flat surface. The red lights on the Quadrone will begin to flash. Do

not move the Quadrone during the syncing process to ensure the

gyroscope stays balanced.

2. Lower the Throttle joystick of the remote to its lowest position. Press the

power button on the remote to turn it on. The remote will beep and

Quadrone's lights will continue flashing.

3. Push the Throttle joystick to its highest position and the remote will

beep again. The lights on the quad will now flash at a slower rate. Move

the joystick to its lowest position one more time and the remote will beep

a third time. The lights on the quad will stop flashing and remain on. The

Quadrone and remote controller have been synced together. You are now

ready to fly.