Charging Your Drone - Quadrone Maximus Instruction Manual

1. Ensure the drone is powered OFF. 2. Open the battery compartment.
4. Connect the battery to
the included USB charger.
*The drone's battery will take up to 3 hours to fully charge.
1. To install the landing gear, simply insert the
landing gear into the bottom of the drone. The
landing gear will snap in when fully inserted.
2. To install the crash guards, insert them into the
slots at the end of each arm. Use the provided
screw and screwdriver to secure the guard
in place.
1. Before installing the camera to the drone, make sure the SD card is
properly inserted into the camera.
2. After the SD card is inserted, plug the camera's plug into the
drone's port as shown in the image.
3. Insert the camera's plug into the drone's spcketto connect the two.

Charging Your Drone

5. Plug the USB charger into
any USB port. The light on the
charger will flash green to
indicate the battery is charging.
When the light stops blinking and
stays on, charging is complete.
Assembling the Drone
Installing the Camera
5
3. Unplug the battery and
remove it from the drone.
6. Reinsert the battery into the
drone and close the cover.