Table of Contents
Advertisement
Cardio Theater Integrated Bracket Assembly Instructions
5
Reinstall the
Bracket Cover
1. Prepare the fasteners for reinstalling the bracket
cover.
Push the washers and bearings toward the bolt
heads so there is room for the bracket cover to
slide in flush against the pivot tube.
Important: Keep the bracket cover flanges flush
with the pivot tube. The washers and bearings
need to remain on the outside of the bracket
flanges.
2. Replace the bracket cover.
Hold the bracket cover above the pivot tube.
Apply pressure to the top of the bracket cover
while you slide it into position.
3. Tighten the top two screws on the back of the
LCD Screen.
Use a Phillips-head screwdriver to fully tighten
the top two screws on the back of the LCD
Screen. Access holes have been drilled through
the bracket cover.
4. Secure the bracket cover.
Using a torque wrench and a ⁷⁄₃₂-inch hex key,
retighten the two pivot tube fasteners to 120 in-lbs.
Reinstall the Bracket Cover
1
Bracket
cover
Pivot tube
3
Bracket cover
Top of the bracket
2
cover
4
Pivot tube
page 12
Advertisement
Table of Contents
