Function Descriptions - Kenwood TK-190 Instruction Manual


This function can be selected only when the scrambler
board has not been installed.

This function can be selected only when the ANI board has
been installed.

This function can be selected only when the scrambler
board has been installed.
Note:
If your dealer programs "Shift" onto a PF key or the toggle switch,
◆
the remaining PF keys can be programmed with an additional
function. To use the additional functions, you must first press and
hold the Shift key, then press the function key you desire. The
toggle switch and the key programmed with "Shift" cannot be
programmed with an additional function.
When the same auxiliary function is programmed onto both a PF
◆
key and the toggle switch, an error will occur on the PF key and it
cannot be used.

Function Descriptions

■
• AUX: Press to turn AUX ON. The dealer selectable
optional board will activate. Press again to turn AUX
OFF. When AUX is ON, "AUX" appears on the display.
• Channel Down: Press to decrease the channel by 
step. Press and hold to continuously scroll through the
channels. Unprogrammed channels will be skipped.
Note: Your dealer can program the "Roll Over" (default) or
"Dead End" feature. When Roll Over is programmed, pressing
Channel Down while you are at the lowest channel will cause
the transceiver to select the highest channel, and begin the
decrease cycle again. When Dead End is programmed,
pressing Channel Down while you are at the lowest channel
will not change the channel number.
• Channel Name: Press to change the display between
the channel number and the channel name. Your dealer
can program a channel name for each channel with up to
7 characters.