Magma 3TX Installation Manual page 12

NOTE
The new Thunderbolt™ 2 Interface card comes with a standard bracket. You need to replace this
bracket with the shorter bracket in order to fit in the EB1T card guide slot.
1. Remove the two mounting screws on the card.
2. Slowly slide the bracket out from the card.
3. Prepare the new bracket for EB1T Thunderbolt™ 2 Interface card as shown from the picture below.
4. Properly align the mounting holes of the card on top of the bracket and secure it firmly.
Thunderbolt™ 2 Interface Card
| Thunderbolt™ 2 for EB1T
Magma
12