Related Manuals for Stages cycling SIP1
Summary of Contents for Stages cycling SIP1
- Page 1 SIP1...
- Page 2 ® Stages Indoor Cycling LLC www.stagesindoorcycling.com support@stagesindoorcycling.com 1-800-717-8076 Sales, Accounting and Administrative ,Tech. Support: 1732 NW Quimby, Ste 250, Portland, OR 97209 USA Design, Manufacturing, and Warehouse: 3090 Sterling Cir, Ste 102, Boulder, CO 80301 USA • Batteries AA x 2 – service life, approximately 2000 hours of riding time •...
- Page 4 52 - 57 Nm (38 - 42 lb-ft)
- Page 5 ANT+ ID # ANT+ ID # SERIAL # ANT+ ID # ANT+ ID # Fig 1 Fig 2...
- Page 6 Pairing the power meter The power meter must be connected or “paired” to the Stages SIC1 display console or cycle computer (collectively referred to as display units) according to the manufacturer’s instructions. Each power meter has a unique ANT+ device ID. During the pairing process the applicable device ID is recorded by the display and will be used to communicate with the corresponding power meter.
- Page 7 Loads applied while pedaling will then be measured as torque and used by the sensor to determine power in Watts. The zero o set value can be a ected by the installation of the crank arm and the tightening of the securing hardware. The torque applied to the securing hardware can impart some strain into the crank material that is easily accounted for by manually calibrating the zero o set.
-
Page 8: Troubleshooting
Troubleshooting If no power (watts) or cadence (RPM) signal is being received by your compatible display unit when riding the bike, please items: Con rm that working AA batteries are properly installed in the power meter according to assembly steps 1-4 on page 3. 2. -
Page 9: Warranty Procedures
Updated firmware may be developed and released by Stages Cycling to provide added or improved functionality. Firmware updates may be sent to the power meter by way of the Stages Cycling Utility Apps for Apple® iOS devices such as iPhone and iPads, as well as Android devices (running Android software 4.4 or newer). - Page 10 Stages Indoor Cycling™ Important Product Information Contact Information: Product Name: Stages Indoor Power Meter Model Name: SIP1 Stages Indoor Cycling LLC FCC ID: ZBM-SIP1 1732 NW Quimby IC ID: 9327A-SIP1 Suite 250 Portland, OR 97209 www.stagesindoorcycling.com Support@stagesindoorcycling.com California Proposition 65 The enclosed hardware and its packaging contain chemicals the State of California has found to cause cancer, birth defects or reproductive harm.
- Page 11 Cycling or an authorized Stages Indoor Cycling Service Provider (h) to defects caused by normal wear and tear or otherwise due to the normal aging of the Stages Cycling Product, or (i) if any serial number has been removed or defaced from the Stages Cycling Product.
- Page 12 Printed using soy ink on 30% recycled, acid free paper 000-4112 Rev.01...
Need help?
Do you have a question about the SIP1 and is the answer not in the manual?
Questions and answers