Charging Battery; Charging Battery (Desktop Holder) - SoftBank 109SH Instruction Manual

Charging Battery (Desktop Holder)

Battery must be inserted in handset to
charge it.
Charging Battery Outside Japan
. SoftBank Mobile is not liable for problems
resulting from charging Battery abroad.
Important AC Charger Usage Note
. Retract blades after charging. Do not
pull, bend or twist cord.
When Notification Lamp is Flashing
. Battery is unchargeable; may be defective
or simply at the end of its life; replace it.
Use Desktop Holder with AC Charger
ZTDAA1 (optional accessory).
. In this guide, ZTDAA1 is referred to as "AC
Charger."
. AC Charger and Desktop Holder are not
water or dust proof. Do not charge
Battery while handset is wet.
. Handset/AC Charger may become warm
while charging.
Connector Port
Release
Tabs
Arrows Down
Notification Lamp
AC 100 V Outlet
3
1
Charger
Charger
Terminal Lever
Connector
Charger Terminals
1
Insert Charger connector
into Desktop Holder
. Insert Charger connector in the
correct orientation until it clicks.
2
Extend blades and plug AC
Charger into AC outlet
3
Place handset into Desktop
Holder
. Push down handset until it clicks into
2
place.
. Notification Lamp illuminates red
Blades
while charging.
. Notification Lamp goes out when
AC Charger
Battery is full.
4
Remove handset from
Desktop Holder
5
Unplug AC Charger
6
Disconnect Charger
connector from Desktop
Holder
. Squeeze release tabs and pull
straight out.
Important Desktop Holder Usage Notes
. Do not subject to force/pressure.
. Do not attempt to open handset.
. Do not get Straps caught between
handset and Desktop Holder.

Charging Battery

5
1-