3.34
Aircraft Registration Number Entry
This section is only applicable to those aircraft that use the GTX 33/33D transponder
configuration loaded per Section 3.21.
1. With PFD1 in configuration mode, select the GTX page group, then select the TRANSPONDER
CONFIGURATION page on PFD1.
2. The 'ADDRESS TYPE' default is 'US TAIL'. To enter a non-US Mode-S registration number
set the 'ADDRESS TYPE' field to 'HEX ID'.
3. Activate the cursor and highlight the 'MODE S ADDRESS' field. Use the small/large FMS
knobs to enter the US aircraft registration number or other Mode-S registration number.
4. For US registered aircraft, the 'FLIGHT ID TYPE' field should be set to 'SAME AS TAIL'.
For other aircraft, the 'FLIGHT ID TYPE' field should be set to 'CONFIG ENTRY' or
'PFD ENTRY'.
The CONFIG ENTRY setting requires the Aircraft Registration/ID number to be entered
once in the 'FLIGHT ID' field. The PFD ENTRY setting allows the pilot to enter the
Aircraft Registration/ID number from the PFD, via the 'TMR/REF' softkey.
5. After each configuration setting change, press the ENT key to configure the transponders.
6. Press the ENT key on PFD1 to acknowledge prompt.
7. After completing transponder configuration, deactivate the cursor.
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
190-00716-01
NOTE
Figure 3-44, Aircraft Registration
NOTE
Page 3-47
Revision 1